Colour: could choose the Gold, Silver, Black, and so on. Use: Manufacturing building doors and windows, Train, Bus, insulating glass, insulating door, shutter, refrigeration equipment and so on.
Using method and attention: All the glass should be dry and clean. The insulating glass should be made by the following steps.
1. Putting the spacer onto the corner of one glass, then making the spacer straight, at the same time keeping the spacer around the surface of the glass, at the end, reserved 2.5mm– 3.0mm to the edge of the glass and the spacer should be reserved about 20mm more joint the pact pressing the joint, making no space in the circle. 2. Then putting another glass onto the one which has the spacer above, making sure the two pieces of glass are mutual alignment in both vertical and horizonal. 3. Putting them into the hot press machine with the temperature between 110–140S inside and 50~60S the outlet. 4. According to the structure requirement of the insulating glass, two component silicone sealant could be putting outside of the spacer. Then a piece of insulating glass should come out. 5. The butyl spacer must be carried out in accordance with this attention otherwise may cause the seal leakage.
Anti-condensation Performance
When encountering a cold climate, there is a large temperature difference between indoor and outdoor, hot inside and cold outside, and condensation will appear on doors and windows. This is because traditional aluminum spacers have very good thermal conductivity, leading to rapid loss of heat on the metal. Therefore, when the doors and windows are warm and cold, the water vapor in the air is more likely to liquefy into small water droplets, which will become dew after gathering. . The warm edge strip has low thermal conductivity, the heat energy on the metal is not easy to lose, the temperature difference between the two sides of the door and window will not be too large, and the phenomenon of condensation will not appear.
Declare:
1.Thickness is customized according to requirements
2.The packing quantity of each carton is decided by model, thickness and length
.Rustless, corrosion, high brightness.
.Surface evenly, straightness, and no deformation and dimensional stability.
.Connected by only one straighter, good sealing with long lifetime.
limit deviation of peripheral wall thickness is ±0.025mm.
High strength, toughness, and with continuous bend to any angle of ending equipment aluminum frame.
Well arranged vents.
To ensure that activities of molecular sieve, guarantees and various types of adhesive with excellent adhesion.
Energy saving and environmental protection, low heat transfer coefficient
Three Kinds : All stainless , Stainless+glassfiber , All glassfiber
The color and thickness is varities and it can be customized .
